Valtra 6x50-8x50 HiTech,
1997 - w12/2005

Valtra HiTech-series has two filters behind the right rear axle. Filters must be moved upper so that JAKE Sleeve Units can be mounted on the axle. JAKE Mounting Kit includes necessary fasteners.

Filters when not compressed air tank

The filter with smaller hoses (3/8") stays behind the right axle but moves upper and toward center. Original hoses and elecric cable are useful. Check that the moving parts of 3-point linkage have enough space to move.

The filter with bigger hoses (1/2") moves to the front of the right rear axle. The fastener delivered with JAKE will be mounted to the hindmost staircase fastener on the side of the tractor frame. Original hose is useful but the electric cable needs an extension.

Filters when compressed air tank

The filter with smaller hoses (3/8") stays behind the right axle but moves upper and toward center. Original hoses and elecric cable are useful. Check that the moving parts of 3-point linkage have enough space to move.

The filter with bigger hoses (1/2") moves to the left side behind the rear axle. JAKE Mounting Kit includes extensions for the hoses and electric cable.

Cabin preparing

Valtra's mudguard (above the axle) must be cut so that JAKE Sleeve Unit fits on place. There are two cuttings on the picture: from above the axle forward and from above the axle back-upward. One bolt of the service hatch stays behind JAKE Sleeve Unit so remove the bolt to open the hatch later without dismounting Sleeve Unit. On the right side there is also a strenghthening profile which must be shortened. Check after mounting that the cabin parts don't touch JAKE parts. (The picture was taken of 2000's Valtra which has a different rear axle than 1990's models. Instructions are valid also for 1990's tractors.)